Your cart is empty

It feels desperately alone.

Continue Shopping
View Reviews (0)
Item #
LR105260S

Vw Type 1 Billet 6¾" Equalizer Crankshaft Engine Pulley 5½ Lbs Cut For Sand Seal

$84.95
VW TYPE 1 BILLET 6¾" EQUALIZER CRANKSHAFT ENGINE PULLEY 5½ LBS CUT FOR SAND SEAL
VW TYPE 1 BILLET 6¾" EQUALIZER CRANKSHAFT ENGINE PULLEY 5½ LBS CUT FOR SAND SEAL

Warning: Cancer and Reproductive Harm. www.p65warnings.ca.gov

Email us at support@vwispwest.com and be sure to include the Item #. Contact Us

We recently launched our new site. Your feedback is appreciated. Email us at support@vwispwest.com and we'll be in touch. Contact Us

New, Equalizer crank pulley. Sold each

Pulley is the Sand Seal Type

Made from steel billet, heavier than the stock pulley to reduce crankshaft vibrations / harmonics / balance

Features:

  • 5½ POUNDS TO BE EXACT STOCK SIZE 6¾" ROUND
  • Pulleys are known to improve crankshaft bearing & engine case lifespan
  • Fully balanced, black zinc plated, with glued in timing degree ring with a deep belt groove
  • designed and modeled after the more expensive "Gene Berg Equalizer GB 440AE"

During installation:

  • check the clearance of the oil pump studs to pulley as you most likely used longer than stock ones for a high volume oil pump.
  • A little bit of Loctite on the threads of the crank pulley bolt and torque to 30 foot pounds.
  • Using a stock length crank bolt and washer

If you are sending the crank, flywheel & rods out for machine balancing, include this pulley too for optimum results.

Fits:

  • anything based off the 1500cc/1600cc Type 1 engine case ( when using a sand seal )

New, Equalizer crank pulley. Sold each

Pulley is the Sand Seal Type

Made from steel billet, heavier than the stock pulley to reduce crankshaft vibrations / harmonics / balance

Features:

  • 5½ POUNDS TO BE EXACT STOCK SIZE 6¾" ROUND
  • Pulleys are known to improve crankshaft bearing & engine case lifespan
  • Fully balanced, black zinc plated, with glued in timing degree ring with a deep belt groove
  • designed and modeled after the more expensive "Gene Berg Equalizer GB 440AE"

During installation:

  • check the clearance of the oil pump studs to pulley as you most likely used longer than stock ones for a high volume oil pump.
  • A little bit of Loctite on the threads of the crank pulley bolt and torque to 30 foot pounds.
  • Using a stock length crank bolt and washer

If you are sending the crank, flywheel & rods out for machine balancing, include this pulley too for optimum results.

Fits:

  • anything based off the 1500cc/1600cc Type 1 engine case ( when using a sand seal )

Reviews

Write a Review