New Bus fuel sending unit fitting Buses to 1967.
Works with 6 volt or 12 volt electrical systems.
Length: 180mm Ohm Range: 7 Full / 70 EmptyMade by ISP West.
Note: This sender can also be used when converting type 1 - 62 to 67 mechanical fuel gauge to electric.
HOW TO install this sender:
Remove sender from box, remove decal on the side of the cylinder, remove the pin that was under the decal.
Once the pin is removed the float is released and your ready to install the unit to the gas tank with the flange seal.
Do not drop or shake it, it will cause the unit to fail or malfunction.
New Bus fuel sending unit fitting Buses to 1967.
Works with 6 volt or 12 volt electrical systems.
Length: 180mm Ohm Range: 7 Full / 70 EmptyMade by ISP West.
Note: This sender can also be used when converting type 1 - 62 to 67 mechanical fuel gauge to electric.
HOW TO install this sender:
Remove sender from box, remove decal on the side of the cylinder, remove the pin that was under the decal.
Once the pin is removed the float is released and your ready to install the unit to the gas tank with the flange seal.
Do not drop or shake it, it will cause the unit to fail or malfunction.
